Loading...
2 results
Search Results
Now showing 1 - 2 of 2
- Ultrasound sonication prior to electrospinning tailors silk fibroin/PEO membranes for periodontal regenerationPublication . Serôdio, Ricardo; Schickert, Sónia L.; Costa-Pinto, Ana R.; Dias, Juliana R.; Granja, Pedro L.; Yang, Fang; Oliveira, Ana L.In this study, silk fibroin (SF)/poly(ethylene oxide) (PEO) membranes were designed and fabricated by combining ultrasound sonication prior to electrospinning (0 to 20 min) as a strategy to physically control the rheological properties of solutions (10 to 30% w/v PEO) and to improve the spinnability of the system. PEO has proved to be essential as a co-spinning agent to assure good membrane reproducibility and enough flexibility for clinical manipulation. The rheological tests indicated that sonication greatly increased the viscosity of SF/PEO solutions and further enhanced the quality of the produced electrospun fibers with consequent improved mechanical properties in dry and wet conditions. By tuning the viscosity of the solutions using a simple sonication step prior to electrospinning, it was possible to induce water stability in the as-electrospun matrix, as demonstrated by infra-red spectroscopy. This reduced complexity in the process since it was not necessary to concentrate silk prior to electrospinning while avoiding the use of toxic solvents to perform a post-processing stabilization treatment which usually causes dimensional changes to the SF materials. Sonication pre-treatment allowed for minimizing the amount of synthetic polymer used to achieve the desirable mechanical properties (with the modulus ranging between 90 and 170 MPa), while avoiding a further water stabilization treatment. It also had a positive impact in the in vitro cell behavior of human primary periodontal ligament cells (hPDLs), resulting in a marked increase in cell proliferation. The present developed work constitutes a step forward towards simplicity and a better fabrication control of viable electrospun SFbased membranes for periodontal regeneration.
- Electrospun polycaprolactone (PCL) degradation: An in vitro and in vivo studyPublication . Dias, Juliana R.; Sousa, Aureliana; Augusto, Ana; Bártolo, Paulo J.; Granja, Pedro L.Polycaprolactone (PCL) is widely used in tissue engineering due to its interesting properties, namely biocompatibility, biodegradability, elastic nature, availability, cost efficacy, and the approval of health authorities such as the American Food and Drug Administration (FDA). The PCL degradation rate is not the most adequate for specific applications such as skin regeneration due to the hydrophobic nature of bulk PCL. However, PCL electrospun fiber meshes, due to their low diameters resulting in high surface area, are expected to exhibit a fast degradation rate. In this work, in vitro and in vivo degradation studies were performed over 90 days to evaluate the potential of electrospun PCL as a wound dressing. Enzymatic and hydrolytic degradation studies in vitro, performed in a static medium, demonstrated the influence of lipase, which promoted a rate of degradation of 97% for PCL meshes. In an in vivo scenario, the degradation was slower, although the samples were not rejected, and were well-integrated in the surrounding tissues inside the subcutaneous pockets specifically created.