A carregar...
Publicação
Effect of machining parameters on the mechanical properties of high dosage short –carbon- fiber reinforced composites
Orientador(es)
Resumo(s)
The machinability of polymer matrix composites with fibers strongly depends on the type of fiber and dosage in question, having a high influence on the selection of tools and cutting parameters. The cutting temperature depends of rotation speed and the feed cutting tools and is significantly influencing on the quality of the machined surfaces and tool life. This paper presents the results of a current study concerning the effect of the rotation-cutting speed on the cutting temperature, roughness and tensile strength of short carbon fiber reinforced epoxy composites, potentially used in automotive and aeronautic industries. Composite plates were manufactured by compression molding, using short carbon fibers with 0.5 mm and 6 mm length. The increasing of the rotation-cutting speed increases significantly the temperature generated in the tool and slightly increases surface roughness. Tensile strength and Young´s modulus are little sensitive to drilling speed. However, above 3000 rpm it was observed significant loss of stiffness, associated with the developed temperature in the machining process. Citation: Oliveira, S. E., Ferreira, J.A.M., Capela, C., da Silva, J., Effect of machining parameters on the mechanical properties of high dosage short-carbon-fiber reinforced composites, Frattura ed Integrità Strutturale, 48 (2019) 249-256.
Descrição
Palavras-chave
Mechanical properties Short fiber composites Machinability of composites.
Contexto Educativo
Citação
Ferreira, J. A. M., Oliveira, S., Silva, J., & Capela, C. (2019). Effect of machining parameters on the mechanical properties of high dosage short –carbon- fiber reinforced composites. Fracture and Structural Integrity, 13(48), 249–256. https://doi.org/10.3221/IGF-ESIS.48.26
Editora
Gruppo Italiano Frattura